Avaya 03-300430 User Manual

This is an Electronic Power Feed (EPF) restoration test. In this test, the processor requests that 
the EPF be turned on for a given port, and an attempt is made to turn on the power supply to the 
station. If no current is drawn, the station is probably not connected. If an overcurrent condition 
is sensed, there may be a short in the loop. A message is returned reporting that either the EPF 
was successfully turned on, or that an overcurrent condition was sensed. This test is repeated 
again 5 seconds later.

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call. 

1. Enter display port WRN to determine the station extension or 

attendant number of the port. 

2. Use status station or status attendant to determine the 

service state of the port. 

●

If the port is in use, wait until the port is idle before testing. 
Attendants are always in use (off-hook) if the handset is plugged in 
and the port is not busied out.

●

If the port status is idle, then retry the command at 1-minute 
intervals up to 5 times.

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2