Avaya 03-300430 User Manual

1

ABRT

This port may have been busied out by system technician.

1. Look in the Error Log for Error Type 18 (port busied out) for this port. If 

this error type is present, then release the port using release 
station extension and run the test again.

2. Make sure that the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

3

ABRT

Station may be in ready-for-service or out-of-service state.

1. Use the status station command to verify the state of the station.
2. Make sure the terminal is connected.

3. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available. The port may 
be busy with a valid call.

1. Use display port WRN to determine the station extension or 

attendant number of the port.

2. Use status station or status attendant to determine the 

service state of the port.

●

If the port is in use, wait until the port is idle before testing. 
Attendants are always in use (off-hook) if the handset is plugged in 
and the port is not busied out.

●

If the port status is idle, then retry the command at 1-minute 
intervals up to 5 times.

1392

ABRT

The port is currently a TTI port and the test will not execute on it.

1. Verify that the port is a TTI port using display port (the display 

shows that the port is a TTI port) or the list config (the display 

shows a t for the port).

2. If list config or display port indicates that the port is not a TTI 

port, escalate the problem. If both commands indicate that the port is a 
TTI port, the abort is correct, and no action is necessary.

FAIL

Internal system error

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3