Avaya 03-300430 User Manual

SIP-SGRP (SIP Signaling Group)

Issue 1 June 2005

1971

Notes:

a. Error Type 0:

Run the short test sequence first. If every test passes, run the long test sequence. Refer to

each appropriate test’s description, and follow its recommended procedures.

b. Error Type 1: Represents a failure of the C-LAN hardware (IP-PROCR in S8300 systems)

carrying the signaling group channel.

To determine which C-LAN had been administered for this signaling group, find the
near-end node name on the signaling group form; then find the C-LAN or IP-PROCR

with the same node name on the ip-interfaces form.
Check for errors against the CLAN-BD MO.

c. Error Type 18: Logged when the signaling group in question is busied out by Craft. Make

sure, if appropriate, that the signaling group is released from busy using the release
signaling-group grp# command.

d. Error Type 257: Tracks failures of the SIP signaling-group PING test. SIP signaling-group

PING test failures are documented later in this MO.

e. Error Type 513: Tracks excessive round-trip delay of the SIP signaling-group PING test, if

the round-trip delay exceeds 4 seconds.

f. Error Type: 770: Tracks excessive latency and packet-loss from background IP

measurements collected by the Media Processor Board. Indicates that test packets sent
from a media processor circuit pack to the far-end ip address specified on the
signaling-group form have exceeded the IP latency and loss thresholds, as

administered on the system-parameters ip-options form. Exceeding these

thresholds indicates that the IP network may not be providing sufficient quality of service for
adequate transmission of voice. If the signaling group has been administered to enable
BYPASS, then error type 1025 also occurs.

1281 (

)

Any

MEDPRO Status test (#1392)

MIN

OFF

1537 (

)

Any

MEDPRO Status test (#1392

MIN

OFF