Avaya 03-300430 User Manual
UDS1-BD (UDS1 Interface Circuit Pack)
Issue 1 June 2005
2411
1300
FAIL
The CSU module/T1 sync splitter or the E1 Sync Splitter is missing.
The CSU module/T1 sync splitter is missing: The Near-End CSU Type
field on the add ds1 screen has been administered as integrated but the
The CSU module/T1 sync splitter is missing: The Near-End CSU Type
field on the add ds1 screen has been administered as integrated but the
120A1 CSU module or the 401A T1 sync splitter is not physically
connected to the UDS1 board on the back of the port carrier.
connected to the UDS1 board on the back of the port carrier.
1. If using the 120A1 CSU module or the 401A T1 sync splitter, plug the
CSU module/T1 sync splitter into the UDS1 circuit pack’s connector
on the I/O connector panel on back of the carrier. Otherwise, set the
Near-End CSU Type field using the change ds1 screen to other.
on the I/O connector panel on back of the carrier. Otherwise, set the
Near-End CSU Type field using the change ds1 screen to other.
2. Run the test again.
The E1 Sync Splitter is missing: The E1 Sync-Splitter? field on the add
ds1 screen has been administered as y but the 402A or 403A E1 Sync
ds1 screen has been administered as y but the 402A or 403A E1 Sync
Splitter is not physically connected to the UDS1 board on the back of the
port carrier.
port carrier.
1. If using the 402A or 403A E1 synchronization splitter, plug the E1SS
into the UDS1 circuit pack’s connector on the I/O connector panel on
back of the carrier. Otherwise, set the E1 Sync-Splitter field using the
change ds1 screen to n.
back of the carrier. Otherwise, set the E1 Sync-Splitter field using the
change ds1 screen to n.
2. Run the test again.
Table 858: Test #138 Loss of Signal Alarm Inquiry Test (continued)
Error
Code
Code
Test
Result
Result
Description / Recommendation
3 of 9