Avaya 03-300430 User Manual

This test is destructive.
This test resets the circuit pack or media module. It is executed as part of the long test 
sequence only for the Tone-Clock circuit pack and DS1 interface circuit packs, and for the 
MM710 DS1 Interface Media Module. Other common circuit packs and media modules can be 
reset with the reset board location command which also executes this test.

None

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1005

ABRT

 / 

:

Wrong circuit pack configuration to run this test. This error applies only to 
DS1 interface circuit packs. It means the DS1 interface circuit pack is 
providing timing for the system and, therefore, it cannot be reset without 
major system disruptions.

1. If the circuit pack needs to be reset, then set synchronization to 

another DS1 interface circuit pack or the Tone-Clock circuit pack and 
try again. See 

:

If this is a G700 media gateway system, and the MM710 DS1 interface 
Media Module under test is providing timing for the platform, it cannot be 
reset without major platform disruptions 
Note: For this type of system the sync timing source is local to the G700.

1. If the MM710 Media Module needs to be reset, then set the 

synchronization timing source to another MM710 DS1 interface Media 
Module located in the same G700 and retest. See 

 in Maintenance Procedures (03-300192).

1015

ABRT

Port is not out-of-service.

1. Busy out the circuit pack or media module.

2. Execute command again.

2100

ABRT

System resources required for this test are not available.

1. Retry the command at 1-minute intervals up to 5 times.

1

FAIL

The circuit pack or media module failed to reset.

 1 of 2