Avaya 03-300430 User Manual

:

1412

ABRT

: On the G700, this test aborts with Error Code 1412.

2000

ABRT

There was no response from the board.

1. If Error Type 1538 (hyperactivity) is present in the error log, follow the 

maintenance strategy that is recommended for this Error Type.

2. Run busyout board location, reset board location, and 

release board location, and retest.

3. If the test still aborts, dispatch with the circuit pack.

4. Check the off-board wiring and the terminal, and, if there are no 

problems found, replace the circuit pack.

FAIL

No ringing current is detected. The ringing application circuitry on this 
circuit pack probably is not healthy.

1. Retry the command again.

2. If the test continues to fail, look for RING-GEN error in Error Log.

a. If there are RING-GEN errors, see 

on page 1942 and try to resolve any problem(s).

b. If there are no RING-GEN errors, then replace the circuit pack.

3. Retry the command again.

PASS

Ringing current is detected or this vintage of the Analog Line circuit pack 

does not support the Ringing Application Circuit Test. Analog Line circuit 

packs that DO NOT support Test #51 include TN712 Vintage 13 and earlier 

and TN742 Vintage 3 and earlier.

Any

NO 

BOARD

This is normal if the test is being done when (a) the board is not physically 
in the system or (b) the system is booting up. Otherwise, there is some 
inconsistency between the physical configuration and the data kept in the 
system.

1. Verify that the board is physically in the system.

2. Verify that the system is not in a stage of booting up.

3. Retry the command at 1-minute intervals up to 5 times.

 2 of 2