Avaya 03-300430 User Manual

This test checks the on-board transmission capabilities of the NPE, the codec, and the battery 
feed chip of the analog port.  The test passes if the signal measured by the Tone Detector is 
within acceptable limits.

0

NO

BOARD

The test could not relate the internal ID to the port (no board).  This could 
be due to incorrect translations, no board is inserted, an incorrect board is 
inserted, or an insane board is inserted.

1. Verify that the board’s translations are correct.  Enter list config, 

and resolve any problems.

2. If the board was found to be correctly inserted in step 1, enter 

3. Enter reset board location
4. Enter release board location
5. Enter test board location long

This should re-establish the linkage between the internal ID and the port.  If 

not, verify that a valid board is inserted.

 3 of 3

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

1000

ABRT

System resources required to run this test are not available.  The port 
may be busy with a valid call.

1. Use display port location to determine the station extension.
2. Use status station to determine the service state of the port. If 

the port is active, wait until it is idle.

3. Retry the command at 1-minute intervals up to 5 times.

 1 of 4