Avaya 03-300430 User Manual

Associated with every recorded announcement is a checksum. In this test, the SP checks a 
stored global checksum covering all recorded announcements against a calculated one and 
returns the results to the maintenance system. If the global checksum failed, maintenance 
requests the SP to check each individual announcement’s checksum.

2000

ABRT

Response to the test request was not received within the allowable time 
period. If Error Type 1538 is present in the Error Log, follow the maintenance 
strategy recommended for this Error Type.

1. Retry the command at 1-minute intervals up to 5 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

ABRT

Internal system error.

1. Retry the command at 1-minute intervals a maximum of 5 times.

FAIL

Test failed. Circuit pack cannot be used. Announcement speech memory is 
cleared when this test fails. Therefore, when the problem has been resolved, 
announcements must be rerecorded or downloaded to the circuit pack. 

1. Reset the circuit pack via reset board PCSS and then run this test 

again. If the test continues to fail, replace the circuit pack and then run 
this test again.

2. If there are recurring alarms on this circuit pack caused by this test 

failing, replace the circuit pack even if Step 1 works.

!

WARNING:

Replacing the circuit pack results in loss of integrated 
announcements. See 

PASS

The communications link between the two processors on the Announcement 

circuit pack is functioning properly. User-reported troubles on this circuit pack 

should be investigated using other circuit pack and port tests. Refer to 

on page 465 for a description of the port tests.