Avaya 03-300430 User Manual

This test determines the current status of the signaling link.  This test passes if the link is 
“bound” to an endpoint and fails if the link is “not bound.”
The definition of the term “bound” for a link depends upon the type of endpoint and may depend 
on the successful completion of procedures at both Layers 2 and 3 of the protocol.  The 
definition of “bound” for ASAI type of endpoint is:

●

ASAI adjuncts and BRI endpoints not administered for MIM initialization (point-to-point):

For endpoints of this type, the signaling link is “bound” when the link is connected at Layer 2 
(L2 established).

1139

ABRT

The PN’s packet bus is out-of-service.

1. Follow the repair procedures for the packet bus.

2. After completing step 1, execute test port location long and 

review the results of the BRI Port Local LAN Looparound test (#618) to 
verify the repair.

1141

ABRT

The PKT-CTRL is out-of-service.

1. Refer to PKT-CTRL maintenance documentation.

 

:

1187

ABRT

The circuit pack, port, or station may have been busied out.

1. Look in the Error Log for Error Type 18 (busied out) for ASAI-BD, 

ASAI-PT, or ASAI-EPT.

2. If this Error Type is present for ASAI-EPT only, use release 

station and run the test again.

3. If this Error Type is present for ASAI-PT and ASAI-EPT, use release 

port and run the test again.

4. If this Error Type is present for ASAI-BD, ASAI-PT, and ASAI-EPT, use 

release board and run the test again.

2012

ABRT

Internal system error

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 5 times.

 1 of 2