Avaya 03-300430 User Manual

30MM 

FAIL

The failure codes only apply to a system equipped with an ATM Switch.  
The letters “MM” refer to the distant or far-end PN, and “NN” to the near-end 

ATM-EI under test.

The test failed for the first connection from the ATM-EI board under test to 

another PN, and the test tone was detected correctly in the forward 

direction (data sent from the PN where the circuit pack under test resides 

was detected correctly in port network MM, but not the opposite direction).

1. Test the active Tone-Clock on the “MM” PN and the PN where the 

ATM-EI under test resides (test tone-clock location).  This 

determines if dial tone is supplied.

2. Ensure that the ATM address of the ATM-EI circuit pack under test 

matches the ATM address on the ATM switch for the port to which this 
circuit pack is connected.  Refer to for the procedure to check the ATM 
port address on the ATM switch.

3. Run Test #241 on the active ATM-EI in port network MM.  If this test 

fails with Error Code 10NN or 30NN, go back to step 2.

If the address was the same, replace the active ATM-EI circuit pack on 
port network MM.

If this test fails with Error Code 20NN or 40NN, replace ATM-EI circuit 
pack with the initial problem.

 7 of 8