Avaya 03-300430 User Manual

1003

ABRT

The system could not allocate a tone receiver for the test.  The system may 
be oversized for the number of Tone Detectors present, or some Tone 
Detectors may be out of service.

1. Verify that at least one Tone Detector resides in this PN.  (Even without 

a TTR-LEV error, the tested circuit pack’s PN could be missing a Tone 
Detector.)

If missing, the test always aborts for this circuit pack, without harming 
the system.

2. Resolve any TONE-PT errors.

3. If neither condition exists, retry the command at 1-minute intervals up 

to 3 times.

1962

ABRT

Every DSPs is busy (an unlikely event).

1. Retry the command at 1-minute intervals up to 3 times.

2000

ABRT

Response to the test was not received within the allowable time period for 
some of the DSPs.

1. If the board is in standby, reset the board and run the test again.

2. Look into the Error Log for Error Type 1218 (bad DSP).  If Error Type 

1218 is not logged against this board, run the DSP test again and see if 
the error persists.

2100

ABRT

Could not allocate the necessary system resources to run this test.

2302

ABRT

Inconsistent uplink message from the ATM-EI board (an unlikely event).

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error

2752

ABRT

The circuit pack in this location is not a TN230X.

 2 of 3