Avaya 03-300430 User Manual

Page of 2574
Communication Manager Maintenance-Object Repair Procedures
634 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
 
Packet Interface Loop Around Test (#598)
This nondestructive test checks the ATM-TRK circuit pack’s packet-bus interface.  The LANHO 
chip sends data through the bus and back to itself.  If the data received is consistent with the 
data sent, the test passes.  The test does not run if the specified PN’s packet bus has a minor 
alarm or is out of service.
ATM Board Reset (#1256)
This test is destructive.
This test checks the sanity of the angel processor using the Sanity and Control Interface (SAKI) 
test (Common Port Board test, #53).  It resets the circuit pack if the SAKI test fails and runs the 
test again.The ATM Board Reset test passes if SAKI can successfully reset and retest the 
board.
Before running the SAKI test, you must:
Move synchronization off the ATM-TRK circuit pack
Busyout the ATM-TRK circuit pack
Table 213: Packet Interface Loop Around Test (#598) 
Error
Code
Test 
Result
Description / Recommendation
2000
ABRT
Test request timed out.
1. Retry the command up to 3 times at 1-minute intervals.
2. If the test fails repeatedly, run reset board location.
3. If the test continues to fail, replace the ATM-TRK circuit pack.
2012
ABRT
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100
ABRT
Could not allocate needed system resources.
1. Retry the command up to 5 times at 1-minute intervals.
ANY
FAIL
Data packet not received correctly by the ATM Interface circuit pack.
1. Retry the command up to 5 times at 1-minute intervals.
2. If the test continues to fail, replace the ATM-TRK circuit pack.
PASS
The Packet Interface test passed.