Avaya 03-300430 User Manual

Notes:

a. Error Type 0

:

 Run the short test sequence first. If every test passes, run the long test 

sequence. Refer to each test’s description, and follow its recommended procedures.

b. Error Type 1

Aux Data 57408: No tip ground is detected on an outgoing call.
Aux Data 57476:

 

Rotary Dial before Wink.

Aux Data 57477:

 

Rotary Dial pulse too early.

Aux Data 57485:

 

Wink too short for a valid signal.

Aux Data 57487:

 

PBX could not get “loop close” signal.

The DS1 Interface circuit pack detected a hardware fault. These errors will cause the Dial 
Tone test (#314) to run and are only considered a problem if the Dial Tone test fails (in which 
case Error Type 1025 will also show up). In this case, the trunk may be put in the 
ready-for-service state (shown as “disconnected” by the status command), which allows 
only incoming calls. Run the Dial Tone test (#314) and follow the procedures.

1025

DS1 CO Dial 

Tone Seizure 

(#314)

MIN

WRN

2

OFF

test trunk grp#/mem# r 2

1281

Conference 

Circuit test (#7)

MIN

ON

test trunk grp#/mem# l r 4

1537

NPE Crosstalk 

test (#6)

MIN

ON

test trunk grp#/mem# l r 3

1793 (

test board location l

2049 (

57473

57474

57475

2305 (

50944

2562 (

)

16665

2817 (

)

52992

3840 (

)

Port Audit and 

Update (#36)

1. This alarm is raised when the 

Base Tone Generator 

field is 4 (Italy) on the System-Parameter 

Country screen. This alarm is MINOR unless 75% or more trunks in this trunk group are out of service, then 
the alarm is upgraded to a MAJOR alarm.

2. Major alarms may be downgraded to Warning alarms based on the value used in set options.

 2 of 2