Avaya 03-300430 User Manual
S-SYN-PT (Speech Synthesis Port)
Issue 1 June 2005
1987
Table 731: TEST #165 Speech Synthesis DSP Tone Test
Error
Code
Code
Test
Result
Result
Description / Recommendation
ABRT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000
ABRT
System resources required to run this test are not available. The port may
be busy with a valid call and therefore unavailable for certain tests. Wait
until the port is idle (amber LED is off) before retesting.
be busy with a valid call and therefore unavailable for certain tests. Wait
until the port is idle (amber LED is off) before retesting.
1. If the port is idle retry the command at 1-minute intervals up to 5 times.
1001
1002
1003
ABRT
System resources required to run this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1021
ABRT
The 440-Hz tone was not detected by the Tone Detector circuit and
inter-digit time-out has occurred on the Tone Detector circuit.
inter-digit time-out has occurred on the Tone Detector circuit.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, verify that every Tone Detector circuit in
the system is functioning correctly by checking the Error Log and using
test board location long. Replace any faulty circuit packs
test board location long. Replace any faulty circuit packs
containing Tone Detector circuits, and repeat the test.
3. If the test continues to abort, replace the Speech Synthesis circuit pack.
2000
ABRT
Response to the test request was not received within the allowable time
period.
period.
1. Retry the command at 1-minute intervals up to 5 times.
2100
ABRT
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
Any
FAIL
The 440-Hz tone was not detected by the Tone Detector circuits.
1. If the test fails again, verify that every Tone Detector circuit in the
system is functioning correctly by checking the Error Log and using
test board location long. Replace any circuit packs containing
test board location long. Replace any circuit packs containing
faulty Tone Detector circuits, and repeat the test.
2. If the test fails again, replace the Speech Synthesis circuit pack.
PASS
The 440-Hz tone has been detected correctly. User-reported troubles should
be investigated using other tests and by verifying other ports on this circuit
pack are working correctly.