Bosch FW5.50 User Manual

Camera Browser Interface

Network | en

Bosch Security Systems

Software manual

AM18-Q0611 | v5.50 | 2012.03

The settings on this page are used to integrate the device into a 

network. Some changes only take effect after a reboot. In this 

case Set changes to Set and Reboot.

1.

Make the desired changes.

2.

Click Set and Reboot.

The device is rebooted and the changed settings are activated. 

If the IP address, subnet mask, or gateway address is changed, 

then the device is only available under the new addresses after 

the reboot.

If a DHCP server is employed in the network for the dynamic 

assignment of IP addresses, activate acceptance of IP 

addresses automatically assigned to the device.

Certain applications (Bosch Video Management System, 

Configuration Manager) use the IP address for the unique 

assignment of the device. If using these applications, the DHCP 

server must support the fixed assignment between IP address 

and MAC address, and must be appropriately set up so that, 

once an IP address is assigned, it is retained each time the 

system is rebooted.

Enter the desired IP address for the camera. The IP address 

must be valid for the network.

Enter the appropriate subnet mask for the set IP address.

For the device to establish a connection to a remote location in 

a different subnet, enter the IP address of the gateway here. 

Otherwise, this field can remain empty (0.0.0.0).