Bosch D625 User Manual

D623 Series/D625 Series | User's Guide | Turn the System Part 2 On (Cmd 3) 

 

 

12 

Bosch Security Systems | 9/04 | 46841E 

 

4.

 

During the last 10 sec. of Exit Delay, the keypad 
displays 

Do not exit!

 and emits a double tone 

every second to warn you not to exit and to turn 
the system off. The system turns Part On. The On 
indicator remains on steady. 

 

5.

 

To turn the system off, enter your passcode. 

Turn the System Part 2 On 

(Cmd 3) 

Exit Delay Time (to be filled in by your security 
company). 

You have __________ sec. to exit premises before 
system turns on. 

 

I can perform this command. 

 

I cannot perform this command. 

Part 2 On turns on the portion of your system 
designated as Part 2, leaving the rest of the system 
turned off. You can select the points that turn on for 
Part 2 On, whereas Part On points are determined by 
your security company (refer to Set Part 2 Points (Cmd 
65) on page 12). Once you press [CMD] [3], the exit 
delay timer countdown begins. 

 

In the following example, 60 sec, is used as the Exit 
Delay. Exit Delay is set by your security company and 
may vary from the example shown below. 
1.

 

Make sure that points are normal (not faulted). 

2.

 

Press [CMD] [3] to turn the system Part 2 On. The 
keypad may prompt you to enter a valid passcode. 

3.

 

Enter your passcode if necessary. The On indicator 
turns on. The keypad display scrolls the following: 

 

Enter your passcode to stop the system from 
turning on during the exit delay. You can turn the 
system Part 2 On with No Delay by pressing [NO 
DELAY], or you may bypass points by pressing 
the [BYPASS] key. 

4.

 

During the last 10 sec. of Exit Delay,  the keypad 
displays 

Do not exit!

 and emits a double tone 

every second to warn you not to exit and to turn 
the system off. The system turns Part 2 On. The 
On indicator remains on steady. 

 

5.

 

Enter your passcode to turn the system off. 

 

Set Part 2 Points (Cmd 65) 

 

I can perform this command. 

 

I cannot perform this command. 

Use this command to program which points are armed 
each time you turn the system Part 2 On. This lets you 
turn part of the system on to detect intrusion, while the 
remaining part of the system lets you move freely 
without sounding an alarm. 
1.

 

Make sure the system is turned off (On indicator is 
off). 

2.

 

Press [CMD] [6] [5]. The keypad may prompt you 
to enter a valid passcode. 

3.

 

Enter your passcode if necessary. The keypad 
display scrolls the following: 

 

4.

 

Enter the Point Number followed by the [*] key to 
toggle between Yes or No for Part 2 On. Repeat 
until all points are programmed Yes or No for Part 
2 Mode (Yes = Active, ready to detect intrusion;  
No = Non-Active, you can move freely without 
sounding an alarm). 

5.

 

Press [CMD] to exit this command. 

Turn the System On with No 

Delay 

This command turns the system All On or Part On 
without entry or exit delays. Remember that turning 
the system on with no delay allows no exit or entry 
delay time through the designated delay point, like the 
Front Door. 
1.

 

Make sure all points are normal (not faulted).