Yamaha RX-V3900 User Manual

Page of 169
36
 En
1
Turn on the video monitor connected to this 
unit.
y
• If you connect two video monitors to the HDMI OUT 
jacks of this unit, press RHDMI OUT repeatedly to select 
the active video monitor(s). See page 37 for details.
• You can operate this unit by using the graphical user 
interface (GUI) screen (page 76).
• You can configure the display settings with “Video” 
(page 93) and “Display Set” (page 98).
2
Rotate the C
INPUT selector (or press one 
of the input selector buttons (3))
The name of the selected input source appears for a 
few seconds.
3
Start playback on the selected source 
component or select a broadcast station.
• Refer to the instruction manuals for the source 
component.
• FM/AM radio tuning (page 48)
• XM Satellite Radio tuning (page 53)
• SIRIUS Satellite Radio tuning (page 58)
• Bluetooth component playback (page 64)
• iPod playback (page 66)
• Playback via USB or network (page 68)
4
Rotate P
VOLUME (or press JVOLUME +/–
to adjust the volume to the desired output 
level.
y
To adjust the level of each speaker, see page 47.
5
Rotate the M
PROGRAM selector (or press 
one of the sound field program selector 
buttons (
Q) repeatedly) to select the desired 
sound field program.
For details about sound field program, see page 40.
y
To switch the information (current input source, current 
sound field program, etc) displayed in the front panel 
display, press 
KINFO (or set the operation mode selector 
to FAMP and then press CINFO) repeatedly.
Playback
Caution
Extreme caution should be exercised when you play 
back CDs encoded in DTS. If you play back a CD 
encoded in DTS on a DTS-incompatible CD player, 
you will only hear some unwanted noise that may 
damage your speakers. Check whether your CD player 
supports CDs encoded in DTS. Also, check the sound 
output level of your CD player before you play back a 
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio 
connection, set “Decoder Mode” in “Input Select” to “DTS” 
before the playback (page 85).
Before performing the following operations, set the operation 
mode selector on the remote control to FAMP.
Basic procedure
DOCK
V-AUX
VCR
DVR
CBL/SAT
DVD
BD/HD DVD
MD/CD-R
TV
CD
PHONO
MULTI CH
TUNER
XM
SIRIUS
D V D
USB
NET
Selected input source
Available input sources
M o v i e
S c i - F i
Selected sound field program
Selected sound field program category