Yamaha RX-V3900 User Manual

y

The results of the measurement that are the causes of the 
warning message(s) appear in yellow or pink.

• “–––” appears when no speaker is connected to the 

corresponding speaker channel or this unit does not measure the 
corresponding speaker channel yet.

• If you change speakers, speaker positions, or the layout of your 

listening environment, run the automatic setup again to 
recalibrate your system.

• The distances displayed in the “Distance” results may be longer 

than the actual distance depending on the characteristics of your 
subwoofer or external amplifiers if you connect them.

• In the “Equalizing” results, different values may be set for the 

same band to provide finer adjustments.

To reload the displayed parameter, press 
9

ENTER.

Press I

MENU to turn off the GUI menu.

y

• You can also set the parametric equalizer type with “PEQ 

Select” (page 91).

• You can set the phase of the connected subwoofer with “Phase” 

(page 88).

Multi Measure 
(Multiple point 
measurement)

Displays the number of listening position 
actually measured.

Wiring 
(Speaker wiring)

Displays the polarity of each connected 
speaker.

– “NRM” appears when the polarity of the 

connected speaker is normal.

– “REV” appears when the polarity of the 

connected speaker is reversed.

– “DET” appears when this unit detects the 

subwoofer is connected.

– “–––” appears when no speaker is 

connected to the corresponding speaker 
channel.

Distance 
(Speaker 
distance)

Displays the speaker distance from the 
listening position. Press 9h repeatedly to 
switch the unit to display the value of the 
each speaker distance.

Size 
(Speaker size)

Displays the size of the connected speakers 
and the bass cross over frequency (“Cross”).

– “LRG” appears when the connected 

speaker has the ability to reproduce the 
low-frequency signals effectively.

– “SML” appears when the connected 

speaker does not have the ability to 
reproduce the low-frequency signals 
effectively. 

Equalizing 
(Speaker 
equalizing)

Displays the result of the adjustment of the 
frequency responses of each connected 
speaker. You can switch the parametric 
equalizer type that appears in the result 
display by pressing 9h repeatedly in the 
“Equalizing” result display. To apply the 
result that is displayed in the display, press 
9ENTER.
Choices: Natural, Flat, Front

– Select “Natural” to average out the 

frequency response of all speakers with 
higher frequencies being less 
emphasized. Recommended if the “Flat” 
setting sounds a little harsh.

– Select “Flat” to average the frequency 

response of all speakers. Recommended 
if all of your speakers are of similar 
quality.

– Select “Front” to adjust the frequency 

response of each speaker in accordance 
with the sound of your front speakers. 
Recommended if your front speakers are 
of much higher quality than your other 
speakers.

Level 
(Speaker level)

Displays the result of the adjustment of each 
connected speaker output level. You can 
display the result of the adjustment of the 
speaker level for each parametric equalizer 
type (see above) by pressing 9h 
repeatedly. Select “Through” to display the 
result when this unit does not use the 
parametric equalizer.