ONKYO ABX-100 User Manual

En-

15

• Make sure your iPod/iPhone is properly seated in the 

ABX-100’s iPod dock. Even very thin iPod/iPhone 
cases can prevent the iPod/iPhone from seating 
properly on the dock connector, so always remove any 
case before inserting your iPod/iPhone (see page 7).

• Make sure the ABX-100 is turned on, the input source 

is set to iPod, and the volume is not set too low.

• Make sure that your iPod/iPhone is compatible with 

the system (see page 4).

• Make sure your iPod/iPhone is properly seated in the 

ABX-100’s iPod dock. Even very thin iPod/iPhone 
cases can prevent the iPod/iPhone from seating 
properly on the dock connector, so always remove any 
case before inserting your iPod/iPhone (see page 7).

• You may not be able to control your iPod/iPhone 

immediately after inserting it into the ABX-100’s iPod 
dock. In this case, wait a few moments until your iPod/
iPhone wakes up.

• Depending on your iPod/iPhone model, its software 

version, or the content your playing, some functions 
may not work as expected (see page 9).

• If your iPod/iPhone does not work, remove it, wait a 

few moments, and then connect it again.

• Check whether there might be a problem with your 

iPod/iPhone. For an iPod touch or iPhone, make sure 
that the app is working correctly.

• Replace the battery with a new one.
• The remote controller is too far away from the 

ABX-100, or there’s an obstacle between them (see 
page 5).

• The ABX-100’s remote control sensor is being 

subjected to bright light (inverter-type fluorescent 
light or sunlight).

• Make sure the turntable has a built-in phono equalizer. 

If the turntable doesn’t have a phono equalizer built-
in, you must provide one.

• Make sure the clock has been set correctly (see 

• Timed operation will fail if the ABX-100 is already on 

at the specified On time, so make sure it’s set to 
Standby (see page 11).

• The timer may overlap with another timer. If you 

program two timers, make sure they don’t overlap.

• If you press the [SLEEP] or [TIMER] button while a 

timed operation is in progress, the timer will be 
cancelled and the ABX-100 won’t turn off at the 
specified Off time (see page 12).

• Make sure the timer is set to suitable volume setting 

(see page 12).

• A power outage has occurred and the time setting lost. 

Set the clock again (see page 11). The timers will all 
be set to Timer Off, so you’ll need to turn on any 
necessary timers (see page 12). The timer settings will 
be preserved.

The ABX-100 contains a microcomputer. In very rare 
situations, severe interference, noise from an external 
source, or static electricity may cause it to malfunction 
or lockup. In the unlikely event that this should 
happen, unplug the AC adapter, wait at least 10 
seconds, and then plug it back in again. If this doesn’t 
resolve the issue, reset the ABX-100 to its factory 
defaults (see page 14).