Edirol UA-20 User Manual
31
Español
Italiano
Français
Deutsch
English
Getting Connected and Installing Drivers (Windows)
Installing the OS-standard driver
■
Windows XP/2000 users
1
With the UA-20 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB
mouse (if used).
mouse (if used).
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
exit it as well.
3
Place the UA-20’s
ADVANCE (mode select) switch
in the
OFF
position.
4
Use the USB cable to connect the UA-20 to your
computer.
computer.
The UA-20 will be detected automatically, and the driver will
be installed.
be installed.
5
When installation is complete, restart Windows.
The procedure for installation and settings will depend on
your system.
Proceed to the appropriate section as follows.
your system.
Proceed to the appropriate section as follows.
• Windows XP/2000 users ...................(p. 31)
• Windows Me users .............................(p. 32)
• Windows 98 users...............................(p. 33)
• Windows Me users .............................(p. 32)
• Windows 98 users...............................(p. 33)
If you are using Windows XP,
the installation has been
completed when the message
near the taskbar saying that
the installation has been
completed when the message
near the taskbar saying that
“Found New Hardware”
has
disappeared.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.