Edirol UA-20 User Manual
32
Getting Connected and Installing Drivers (Windows)
■
Windows Me users
1
With the UA-20 disconnected, start up Windows.
Disconnect all USB cables except for a USB keyboard and USB
mouse (if used).
mouse (if used).
2
Exit all currently running software (applications).
If you are using a virus checker or similar software, be sure to
exit it as well.
exit it as well.
3
Place the UA-20’s
ADVANCE (mode select) switch
in the
OFF
position.
4
Use a USB cable to connect the UA-20 to your
computer.
computer.
fig.05-23e_30
5
Windows will detect the
UA-20, and the
UA-20, and the
“Add
New Hardware Wizard”
dialog box will appear.
Make sure that
Automatic
search for a better driver (Recommended)
is selected, and
click
[Next]
.
6
Driver detection will begin.
7
When the driver has been found, driver installation
will begin.
will begin.
fig.05-24e_30
8
Once the driver has been
installed, a dialog box
will inform you of this.
installed, a dialog box
will inform you of this.
Click
[Finish]
.
This unit is equipped with a
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
protection circuit. A brief
interval (a few seconds) after
connecting a USB connector is
required before the unit will
operate normally.
Depending on your system, a
certain amount of time may be
required for the device to be
detected after the driver has
been installed.
certain amount of time may be
required for the device to be
detected after the driver has
been installed.