Cardo Q2 User Manual

Reconnecting the Intercom: If the scala rider Q2 and its Intercom

Buddy headset go out of range and disconnect from each other, the

scala rider Q2 will automatically try to reconnect to its Intercom

Buddy for five minutes.

You can manually reconnect at any time by pressing the MC Button

(single tap for Primary Buddy and double tap for Secondary Buddy).

Receiving Intercom calls

If you are not speaking with any one, once the other party tries to

initiate a Buddy Intercom call, the call will begin immediately.

TROUBLESHOOTING THE INTERCOM:

First, make sure your microphone is located properly in front of

the center of your mouth.

The scala rider Q2 is designed for use in loud environments.

Please make sure to test the Intercom functionality in a LOUD

environment, such as next to an idling motorcycle.

Please also verify that the headsets were paired together properly

by following the instructions in the relevant Setup sections.

Setting Voice Connect Intercom preference (Primary vs.

Secondary Buddy)

The headset’s Voice Connect feature allows you to start a Buddy

Intercom call by simply speaking into the microphone. You can

define which of the two Buddy headsets you wish to connect to

when using Voice Connect Intercom.
NOTE: The Primary Buddy has priority by default.

To toggle the Voice Connect Intercom between Primary and

Secondary Buddy:

Press and hold the Volume Up Button for three seconds and

you will hear a beep:

• One beep – Voice Connect set to Primary Buddy

• Two beeps – Voice Connect set to Secondary Buddy

Enable/Disable Voice Connect feature
Press and hold the Volume Up and Down Buttons simultaneously

until you hear a beep. The default status is Voice Connect enabled.
NOTE: The Enable/Disable Voice Connect feature affects the

Intercom functionality only.

MAKING AND RECEIVING MOBILE

PHONE CALLS

PHONE FUNCTIONS

Answer a call

Short press the CTRL Button or speak loudly any

word of your choice during an incoming call.

Reject a call

Short press the MC Button or remain silent for

15 seconds during an incoming call.

Terminate a call

Short press the CTRL Button to end a call.

Voice Dial

During Standby, short press the CTRL Button

and state the name of the person you wish to

call. This feature is supported only by mobile

phones that support the Voice Dial feature.

Redial

Press and hold the Volume Down Button for

three seconds during Standby.

NOTE: If your Bluetooth mobile phone is paired to a Bluetooth GPS

device, not directly to the scala rider Q2, some of the above Phone

functions may not be compatible.

scala rider

™

MultiSet