Xantrex Technology 10 User Manual

Installation

2–4

975-0251-01-01

Before installing the inverter in a recreational vehicle, you must consider factors 
such as:

•

“Location” (see page 2–4)

•

•

•

•

“Residual Current Circuit Breaker” (see page 2–7)

•

“Remote Control Wiring” (see page 2–7)

•

•

The following factors should be considered when planning to install the 
Freedom 10.

1. The chassis ground bonding lug is located on the bottom of the unit. Be 

sure to make this connection before bolting the unit down.

2. Always mount the unit in a dry area, out of direct contact with water or 

spray.

3. You may mount the unit horizontally (on a shelf) or vertically (on a wall or 

bulkhead). If mounted vertically, you must orient the unit so the switch and 
circuit breakers are facing up and the fan and battery cables are facing down.

Figure 2-1 Ground, AC, and Remote Connection Locations

Remote Jack

Chassis Ground 
Bonding Lug

May be used with 
optional TC 2+2 
(Battery Temp. 
Sensor)

For future use