Xantrex Technology 815-2524-02 User Manual
26
Freedom SW 230V Installation Guide
Installing the Inverter/Charger
7.
Using a 6 mm blade slot screwdriver, loosen the terminal
screws on the terminals. Do not remove the screws.
screws on the terminals. Do not remove the screws.
8.
Connect the line and neutral wires to the input terminals
(labeled AC Input on the terminal block, Figure 6 on page 25)
as follows:
Connect Line to INPUT L, Neutral to INPUT N.
(labeled AC Input on the terminal block, Figure 6 on page 25)
as follows:
Connect Line to INPUT L, Neutral to INPUT N.
9.
Tighten the terminal screws. Leave some slack wire inside the
wiring box.
wiring box.
10. Connect the ground wires to a free position on the ground bus,
Figure 6 on page 25. If solid ground wire is being used, the wire
can be connected directly under the screw heads. If stranded
ground wire is being used, ring terminals must also be used.
can be connected directly under the screw heads. If stranded
ground wire is being used, ring terminals must also be used.
11. Secure the strain-relief clamp on the AC input cable jacket.
Freedom SW 3K2K 230V InvChg Install Guide.book Page 26 Friday, June 20, 2014 9:11 AM