Xerox 32N00467 User Manual

The page layout is too 
complex.

Reduce the resolution setting from 600 dpi to 
300 dpi. Install more RAM in the computer.

The page orientation may 
be incorrect.

Change the page orientation in the printer setup 
dialog.

The computer parallel 
port may not be set for 
high speed 
communications.

If the computer is equipped with an ECP parallel 
port, enable this mode of operation. Refer to the 
Enabling High Speed Printer Communications 
section of the PC’s user guide.

Computer may not have 
enough memory (RAM).

Install more RAM in the computer.

Print job is too large

Reduce resolution from 1200 dpi to 600 dpi.

There is a paper quality 
problem.

Use only paper that meets the specifications 
required by the product.

Toner may be unevenly 
distributed.

Remove the Toner Cartridge and shake it gently 
to distribute the toner evenly. Then reinstall the 
toner cartridge.

There is a paper quality 
problem.

Use only paper that meets the specifications 
required by the product.

The paper may be too 
dry.

Try printing with a different batch of paper.

The paper may be too 
damp.

Try printing with a different batch of paper. Do 
not open packages of paper until necessary so 
that the paper does not absorb too much 
moisture from the air.

Printing over uneven 
surfaces.

If printing onto envelopes, change the printing 
layout to avoid printing over areas that have 
overlapping seams on the reverse side.

The paper may be too 
damp.

Try printing with a different batch of paper. Do 
not open packages of paper until necessary so 
that the paper does not absorb too much 
moisture from the air.

The transfer roller may be 
dirty.

Print a few blank pages to clean the transfer 
roller.

TrueType fonts may be 
disabled.

Use the fonts dialog box in the Control Panel to 
enable TrueType fonts.