Hughes DW6000 User Manual

This section describes the LEDs’ appearance during typical DW6000 operation. 
Refer to Figure 11 for the LED’s locations.

When the DW6000 is powered on and transmitting or receiving data: 

• The LAN LED is on. The LED blinks off momentarily when frames are 

transmitted or received.

• The Transmit LED is on. The LED blinks off momentarily when frames are 

transmitted.

• The Receive LED is on. The LED blinks on momentarily when frames are 

received.

• The System LED is on.
• The Power LED is on.

The DW6000 Ethernet LAN link has two indicators on the rear of the unit on the 
top of the LAN port. The green indicator shows link status. The yellow indicator 
shows traffic speed. Figure 17 illustrates the Ethernet link LEDs.

Note:

If the Power LED blinks, the DW6000 is running the 

fallback.bin. This will usually happen when the unit is first 
installed. The unit may run the fallback.bin if the main.bin does 
not successfully load; in this case, power cycle the unit.

Figure 10: Ethernet port LED operation