Nortel Networks NN44200-313 User Manual
20
CallPilot resource configuration
Prompt
Response
Notes
CSQI
xxx
Enter the number of CallPilot
DS0 channels multiplied by 2.
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
DS0 channels, enter 48.
CSQO
xxx
Enter the number of CallPilot
DS0 channels multiplied by 2.
DS0 channels multiplied by 2.
For example, if there are 24
DS0 channels, enter 48.
DS0 channels, enter 48.
4
To exit the overlay, enter ****.
—End—
Defining CallPilot in the customer data block (LD 15)
Tech tip: To view current system parameters, go to LD 21 and enter PRT at
the REQ prompt, and then CDB and the appropriate customer number. The
result is a list of all the current information in the Customer Data Block. Use
the capture text function in hyperterminal to save a text file of the output.
the REQ prompt, and then CDB and the appropriate customer number. The
result is a list of all the current information in the Customer Data Block. Use
the capture text function in hyperterminal to save a text file of the output.
Step
Action
1
Connect to the PBX.
2
Enter LD 15.
3
Enter the appropriate values as described in the following table to
add Call Park Allowed and Message Center Included. For prompts
not listed in the following table, press Enter to accept the default.
add Call Park Allowed and Message Center Included. For prompts
not listed in the following table, press Enter to accept the default.
Table 5
LD 15 - Configuring Call Park Allowed and Message Center Included
LD 15 - Configuring Call Park Allowed and Message Center Included
Prompt
Response
Notes
REQ
CHG
TYPE
ftr
CUST
xx
Customer number for CallPilot.
OPT
CPA MCI
IDEF
YES
NO
If Call Forward by Call Type
(CFCT) is enabled on the CS
1000 or M1 switch, enter YES.
(CFCT) is enabled on the CS
1000 or M1 switch, enter YES.
Otherwise, enter NO.
Nortel CallPilot
Quickstart Guide
NN44200-313
01.02
Standard
5.0
19 May 2008
Copyright © 2007-2008, Nortel Networks
.