ZyXEL Communications WAP3205 User Manual

Chapter 12 Maintenance

WAP3205 User’s Guide

Note: If you uploaded the default configuration file you may need to change the IP 

address of your computer to be in the same subnet as that of the default 
WAP3205 IP address (192.168.1.2). See 

 for details 

on how to set up your computer’s IP address.

System restart allows you to reboot the WAP3205 without turning the power off. 

Click Maintenance > Reset/Restart to open the following screen. 

Figure 72   Maintenance > Reset/Restart

Click Restart to have the WAP3205 reboot. This does not affect the WAP3205's 
configuration.

Upload 

Click Upload to begin the upload process.

Note: Do not turn off the WAP3205 while configuration file upload is in 

progress.

After you see a “configuration upload successful” screen, you must then 
wait one minute before logging into the WAP3205 again. The WAP3205 
automatically restarts in this time causing a temporary network 
disconnect.

If you see an error screen, click Back to return to the Backup/Restore 
screen.

Reset

Pressing the Reset button in this section clears all user-entered 
configuration information and returns the WAP3205 to its factory 
defaults.

You can also press the RESET button on the rear panel to reset the 

factory defaults of your WAP3205. Refer to the chapter about 

introducing the Web Configurator for more information on the 

RESET button.

Table 48   Maintenance > Backup/Restore