Nortel Networks 2700 User Manual
Chapter 2 Cabling the VPN Router and turning the power on 39
Nortel VPN Router Installation — VPN Router 2700
Verifying a successful installation
After you connect the gateway to the power source and turn it on, you can verify a
successful installation by checking the LEDs on the front panel (
successful installation by checking the LEDs on the front panel (
The following sequence of LEDs occurs:
1
The power LED (the Nortel Networks logo) lights blue.
2
As the gateway boots, the Boot/Ready LED lights yellow.
3
When the boot process is complete, the Boot/Ready LED lights green,
indicating that the gateway is operational.
indicating that the gateway is operational.
4
The Alert/Fail LED lights yellow because the gateway is not configured.
For a newly installed VPN Router 2700, a yellow Alert/Fail LED does not
indicate an alarm condition. After you configure the management IP address
on the gateway, the Alert/Fail LED turns off. (See
indicate an alarm condition. After you configure the management IP address
on the gateway, the Alert/Fail LED turns off. (See
If the LEDs on the front panel light in this sequence, your installation is
successful. If the LEDs do not light in this sequence, check that the bezel is on the
gateway and that the power cord is properly attached to the power supply (see
successful. If the LEDs do not light in this sequence, check that the bezel is on the
gateway and that the power cord is properly attached to the power supply (see
If the VPN Router 2700 still does not boot, contact your local Nortel Technical
Solutions Center (see
Solutions Center (see
).