Siemens S323 User Manual

UMN:CLI                                                                                                                                                              User  Manual 

SURPASS hiD 6615 S223/S323 R1.5 

180                                                                         A50010-Y3-C150-2-7619 

To configure VLAN on user’s network, use the following command. 

 VLANS Bridge 

Creates new VLAN by assigning VLAN ID: 
VLANS: enter the number of VLAN ID (from 1 to 4094).

 

The variable VLANS is a particular set of bridged interfaces. Frames are bridged only 
among interfaces in the same VLAN. 

 

By default, PVID 1 is specified to all ports. You can also configure PVID. To configure 
PVID in a port, use the following command. 

 PORTS PVIDS Bridge 

Configures VLAN PVID: 
PORTS: enter the port numbers.   
PVIDS: enter the PV IDs (1 to 4094 multiple entries 
possible). 

 

To assign a port to VLAN, use the following command. 

 VLANS PORTS {tagged 

| untagged} 

Assigns a port to VLAN: 
VLANS: enter the VLAN ID. 
PORTS: enter the port number. 

 VLANS PORTS 

Bridge 

Deletes associated ports from specified VLAN: 
VLANS: enter the VLAN ID. 
PORTS: enter the port number to be deleted. 

 

When you assign several ports to VLAN, you have to enter each port separated by a 
comma without space or use dash mark “-“ to arrange port range. 

 

To delete VLAN, use the following command. 

 VLANS 

Bridge 

Deletes VLAN, enter the VLAN ID to be deleted. 

 

When you delete VLAN, all ports must be removed from VLAN before, see the below 
procedure.