Siemens S323 User Manual

User Manual                                                                               UMN:CLI 
SURPASS hiD 6615 S223/S323 R1.5 

A50010-Y3-C150-2-7619                                                                         181 

To display a configuration of VLAN, use the following command. 

 [VLANS] 

Enable 

Global 
Bridge 

Shows the configuration for specific VLAN, enter VLAN 
ID. 

 

User can use a VLAN mapping that associates a set of processes within stations to a 
VLAN rather than the stations themselves. Consider a network comprising devices sup-
porting multiple protocol suites. Each device may have an IP protocol stack, an AppleTalk 
protocol stack, an IPX protocol stack and so on. 

If we configure VLAN-aware switches such that they can associate a frame with a VLAN 
based on a combination of the station’s MAC source address and the protocol stack in 
use, we can create separate VLANs for each set of protocol-specific applications. 

To configure protocol-based VLAN, follow these steps. 

1.  Configure VLAN groups for the protocols you want to use. 
2.  Create a protocol group for each of the protocols you want to assign to a VLAN. 
3.  Then map the protocol for each interface to the appropriate VLAN 

  PORTS  [ethertype 

] <1-4094> 

Configures protocol based VLAN. 
PORTS: input a port number 
ETHERTYPE: 0x800 
1-4094: Vlan ID 

no vlan pvid PORTS ethertype

 

[ETHERTYPE] 

Bridge 

Removes protocol based VLAN. 

 

Because Protocol Based VLAN and normal VLAN run at the same time, Protocol Based 
VLAN operates only matched situation comparing below two cases. 
1.  When Untagged Frame comes in and matches with Protocol VLAN Table, tags PVID 
 

which configured on Protocol VLAN. But in no matched situation, tags PVID which 

 

configured on and operates VLAN.   

2.  When Tagged Frame comes in and VID is 0, it switches by Protocol VLAN Table. But 
 

if VID is not 0, it switches by normal VLAN Table. 

 

In order to configure VLAN based on MAC address, user should designate MAC address. 
use the following command.