ZyXEL Communications 782R User Manual
Prestige 782R G.SHDSL Router
Remote Node Configuration
4-5
Figure 4-3 Menu 11.2 – Remote Node PPP Options
The following table describes the Remote Node PPP Options menu and how to configure the PPP options.
Table 4-2 Remote Node PPP Options Menu Fields
FIELD
DESCRIPTION
OPTIONS
Standard PPP
Encapsulation
Select Standard PPP. Select CISCO PPP only if
the node is a Cisco computer.
the node is a Cisco computer.
CISCO PPP
Compression
Turn on/off Stac Compression. The default is No.
Yes/No
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
4.2 Remote Node Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Layer Options as shown next.
Step 1. In Menu 11.1, make sure IP is among the protocols in the Route field. The Route field should
display IP or IP+IPX.
Step 2. Move the cursor to the Edit IP/IPX/Bridge field, press [SPACE BAR] to toggle and set the
value to Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network Layer
Options.
Options.
Menu 11.2 - Remote Node PPP Options
Encapsulation= Standard PPP
Compression= No
Compression= No
Enter here to CONFIRM or ESC to CANCEL:
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.