Xerox 5400 User Manual
86
Xerox Phaser 5400 Laser Printer
Troubleshooting
Diagnostic LED flash sequences
When the printer is powered ON, it runs a sequence of self test diagnostics. Some failures
are detected in these tests and are identified by a flashing sequence indicated on the
system controller diagnostic LED located on the controller board at the rear of the printer.
are detected in these tests and are identified by a flashing sequence indicated on the
system controller diagnostic LED located on the controller board at the rear of the printer.
Flash sequence
Description and corrective action
1 flash —1 second — 1 flash…etc. A System controller CPU fault has occurred.
Contact your Customer Support Center.
2 flashes — 1 second — 2
flashes…etc.
A Base RAM fault has occurred.
Contact your Customer Support Center.
3 flashes — 1 second — 3
flashes…etc.
flashes…etc.
A ROM
fault has occurred.
Contact your Customer Support Center.
4 flashes — 1 second — 4
flashes…etc.
flashes…etc.
An ASIC or timer fault has occurred.
Make sure the controller board is firmly seated.
If the problem is not resolved, contact your Customer
Support Center.
5 flashes — 1 second — 5
flashes…etc.
flashes…etc.
A resolution enhancement self-test fault has occurred.
Contact your Customer Support Center.
6 flashes — 1 second — 6
flashes…etc.
flashes…etc.
A communications ports internal loopback test fault has
occurred.
Contact your Customer Support Center.
8 flashes —1 second — 8 flashes...etc.
A system controller to print engine fault has occurred.
Make sure the controller board is firmly seated.
If problem is not resolved, contact your Customer Support
Center.
9 flashes — 1 second — 9 flashes...etc.
A hard disk failure has occurred.
Make sure the hard drive is firmly seated on the Controller
Board.
If problem is not resolved, contact your Customer Support
Center.
10-12 flashes — 1 second — 10-12
flashes…etc.
flashes…etc.
A slot DIMM1 - DIMM3 fault has occurred:
10 flashes = DIMM1 fault
11 flashes = DIMM2 fault
12 flashes = DIMM3 fault
Power OFF the printer, remove and reinstall the DIMM, and
Power ON the printer.
If still flashing at Power ON, replace the DIMM.
15 flashes — 1 second —15
flashes...etc.
flashes...etc.
An image enhancement fault has occurred.
Contact your Customer Support Center.