Lexmark 26C0235 User Manual

•

To optimize performance and minimize jams, do not use envelopes that:

–

Have excessive curl or twist

–

Are stuck together or damaged in any way

–

Have windows, holes, perforations, cutouts, or embossing

–

Have metal clasps, string ties, or folding bars

–

Have an interlocking design

–

Have postage stamps attached

–

Have any exposed adhesive when the flap is in the sealed or closed position

–

Have bent corners

–

Have rough, cockle, or laid finishes

•

Adjust the width guides to fit the width of the envelopes.

Note: A combination of high humidity (over 60%) and the high printing temperature may wrinkle or seal envelopes.

Tips on using paper labels

Print samples on the labels being considered for use before buying large quantities.

Note: Use only paper label sheets.

When printing on labels:

•

From MarkVision Professional, the printer software, or the printer control panel, set the Paper Type to Labels.

•

Use only letter

‑, A4‑, or legal‑size label sheets.

•

Use labels designed specifically for laser printers. Check with the manufacturer or vendor to verify that:

–

The labels can withstand temperatures up to 200°C (392°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.

–

Label adhesives, face sheet (printable stock), and topcoats can withstand up to 25 psi (172 kPa) pressure without
delaminating, oozing around the edges, or releasing hazardous fumes.

•

Do not use labels with slick backing material.

•

Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and cartridge warranties.

•

Do not use labels with exposed adhesive.

•

Do not print within 1 mm (0.04 in.) of the edge of the label, of the perforations, or between die

‑cuts of the label.

•

Be sure adhesive backing does not reach to the sheet edge. Zone coating of the adhesive at least 1 mm (0.04 in.)
away from edges is recommended. Adhesive material contaminates the printer and could void the warranty.

•

If zone coating of the adhesive is not possible, remove a 1.6 mm (0.06 in.) strip on the leading and driver edge, and
use a non

‑oozing adhesive.

•

Portrait orientation works best, especially when printing bar codes.

Tips on using card stock

Card stock is heavy, single

‑ply specialty media. Many of its variable characteristics, such as moisture content, thickness,

and texture, can significantly impact print quality. Print samples on the card stock being considered for use before
buying large quantities.

Printing