DELL S50V User Manual

Page of 1262
446
|
Interfaces
www.dell.com | support.dell.com
To test the condition of cables on 10/100/1000 BASE-T modules, use the
 
tdr-cable-test
 
command:
 
Link Debounce Timer
e
This feature is supported on E-Series ExaScale 
e
with FTOS 8.2.0.1 and later
The Link Debounce Timer feature isolates upper layer protocols on Ethernet switches and routers from 
very short-term, possibly repetitive interface flaps often caused by network jitter on the DWDM equipment 
connecting the switch and other devices on a SONET ring. The Link Debounce Timer delays link change 
notifications, thus decreasing traffic loss due to network configuration. All interfaces have a built-in timer 
to manage traffic. This feature extends the time allowed by the upper layers.
The SONET ring has its own restore time whenever there is a failure. During this time, however, 
the Ethernet interface connected to the switch will flap. Link Debounce Timer instructs the 
Ethernet switch to delay the notification of the link change to the upper layers. If the link state 
changes again within this period, no notification goes to the upper layers, so that the switch 
remains unaware of the change.
Important Points to Remember about Link Debounce Timer
Link Debounce Timer is configurable on physical ports only.
Only 1G fiber, 10/100/1000 copper, 10G fiber, 10G copper are supported.
This feature is not supported on management interfaces or SONET interfaces.
Link Debounce takes effect only when the operational state of the port is up. 
Link Debounce is supported on interfaces that also have link dampening configured. 
Unlike link dampening, link debounce timer does not notify other protocols. 
Step
Command Syntax
Command Mode
Usage
1
tdr-cable-test gigabitethernet
 
<slot>/
<port>
 
EXEC Privilege
To test for cable faults on the GigabitEthernet 
cable.
Between two ports, the user must not start 
the test on both ends of the cable. 
The user must enable the interface before 
starting the test.
The port should be enabled to run the test 
or the test prints an error message.
2
show tdr gigabitethernet
 <slot>/
<port>
 
EXEC Privilege
Displays TDR test results.
Note: Enabling the link debounce timer causes link up and link down detections to be delayed, resulting in 
traffic being blackholed during the debouncing period.  This situation might affect the convergence and 
reconvergence of some Layer 2 and Layer 3 protocols.