DELL 9.8(0.0) User Manual
• aggressive: Change the link state to “error-disabled”
when a far-end failure is detected by the software on that
interface. When an interface is placed in an “error-
disabled” state, you must enter the fefd reset
command to reset the interface state. Range is normal or
aggressive. Default is normal.
Defaults
Disabled.
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.12.0
Introduced on the S4810.
Usage
Information
Information
When you enter no fefd for an interface and fefd-global, FEFD is enabled on
the interface because the no fefd command is not retained in the configuration
file. To keep the interface FEFD disabled when the global configuration changes,
use the fefd reset command.
the interface because the no fefd command is not retained in the configuration
file. To keep the interface FEFD disabled when the global configuration changes,
use the fefd reset command.
Related
Commands
Commands
•
•
•
fefd disable
Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
S4820T
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults
Not configured.
Command
Modes
Modes
INTERFACE
Layer 2
1137