DELL 9.8(0.0) User Manual
Related
Commands
Commands
— enables LLDP globally.
— debugs LLDP.
— displays the LLDP neighbors.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
S4820T
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
To revert to the default, use the no hello seconds command.
Parameters
seconds
Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Defaults
30 seconds
Command
Modes
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Link Layer Discovery Protocol (LLDP)
1153