DELL 9.8(0.0) User Manual
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
S4820T
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
To return to the default, use the no multiplier integer command.
Parameters
integer
Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
declares the interface dead. The range is from 2 to 10.
Defaults
4 x hello
Command
Modes
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.7.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
protocol lldp (Configuration)
Enable the LLDP globally on the switch.
S4820T
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Enabled.
Link Layer Discovery Protocol (LLDP)
1155