DELL 9.8(0.0) User Manual
Usage
Information
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
passive-interface command with the neighbor command.
Related
Commands
Commands
— sets the interface to only listen to RIP broadcasts.
network
Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
S4820T
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address
Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
cannot specify a subnet.
Defaults
No RIP network is configured.
Command
Modes
Modes
ROUTER RIP
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.8.1.0
Introduced on the S-Series.
7.6.1.0
Introduced on the C-Series.
pre- 6.2.1.1
Introduced on the E-Series.
1526
Routing Information Protocol (RIP)