DELL 9.8(0.0) User Manual
Usage
Information
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address the network command
specifies.
specifies.
offset-list
Specify a number to add to the incoming or outgoing route metrics learned using RIP.
S4820T
Syntax
offset-list prefix-list-name {in | out} offset [interface]
To delete an offset list, use the no offset-list prefix-list-name {in |
out} offset [interface] command.
To delete an offset list, use the no offset-list prefix-list-name {in |
out} offset [interface] command.
Parameters
prefix-list-
name
name
Enter the name of an established Prefix list to determine
which incoming routes are modified.
which incoming routes are modified.
offset
Enter a number from zero (0) to 16 to be applied to the
incoming route metric matching the access list specified. If
you set an offset value to zero (0), no action is taken.
incoming route metric matching the access list specified. If
you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or
number information:
number information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Defaults
Not configured.
Command
Modes
Modes
ROUTER RIP
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Routing Information Protocol (RIP)
1527