DELL 9.8(0.0) User Manual
Version
Description
9.7(0.0)
Introduced on the S6000-ON.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.11.1
Introduced on the S55, S60, and S4810
8.1.1.0
Introduced on the E-Series ExaScale.
7.5.1.0
Introduced on the C-Series.
pre-Version
6.2.1.0
6.2.1.0
Introduced on the E-Series.
Usage
Information
Information
This command is found on the Management interface only.
Related
Commands
Commands
(either the Primary or Standby RPM).
— configures duplex mode on physical interfaces with
the speed set to 10/100.
interface or a forwarding router.
stack-unit portmode
You can split a single 40G port into four-10G ports.
S4820T
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit
Enter the stack member unit identifier of the stack member
to reset. For the S4820T, the range is from 0 to 11.
to reset. For the S4820T, the range is from 0 to 11.
number
Enter the port number of the 40G port to be split. Enter one
of the following port numbers: 48, 52, 56, or 60.
of the following port numbers: 48, 52, 56, or 60.
Defaults
Disabled.
Command
Modes
Modes
CONFIGURATION
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
852
Interfaces