Allied Telesis fast ethernet 10/100 hubs User Manual
AT-FH812u and AT-FH824u User’s Guide
13
Hub
Configuration
Use the Hub Configuration screen to configure any hub in the stack. This menu is
used to configure the selected hub, as well as the Agent Module. Use the menu in
Figure 8 to view a basic description of all the hubs in the stack, including hardware
and firmware version numbers, or to open a more detailed configuration screen for
a specific hub. The information provided in Figure 8 is described in Table 7 and
Table 8, and in Figure 9:
used to configure the selected hub, as well as the Agent Module. Use the menu in
Figure 8 to view a basic description of all the hubs in the stack, including hardware
and firmware version numbers, or to open a more detailed configuration screen for
a specific hub. The information provided in Figure 8 is described in Table 7 and
Table 8, and in Figure 9:
Hub Selection
Menu
------------------------------------------------------------
Hub Configuration: Hub Selection Menu
Hub H/W EPROM FLASH PORT SNMP Switch Detailed
ID Version F/W Ver F/W Ver
Number Agent
Module
Screen
---------------------------------------------------------------
1. 1
0.11
0.03
24
Master None <GO>
<PREV_PANEL>
Go to hub configuration detailed screen.
Use TAB or Cursor keys to move, <Enter> to confirm.
------------------------------------------------------------
Figure 8 Hub Selection Menu
Table 7 Hub Selection Parameters
Parameters
Description
Hub ID
Hub identifier in stack. (Up to 6 hubs may be connected via the
stack cable.)
stack cable.)
H/W version
Hardware version number of the repeater board.
EPROM F/W ver
Version number of the repeater firmware in permanent
memory.
memory.
Flash F/W ver
Version number of the repeater firmware in temporary memory.
Port Number
Indicates whether this device has 12 or 24 repeater ports.
SNMP Agent
Indicates whether an Agent Module is installed in this hub.
Switch Module
Indicates whether an Internal Switch Module is installed in this
hub.
hub.