Allied Telesis fast ethernet 10/100 hubs User Manual
AT-FH812u and AT-FH824u User’s Guide
15
Table 8 Hub Configuration Parameters
Parameters
Description
Hub
Hub ID
Hub identifier in stack.
Serial No
Serial number of this hub.
10M Backplane
Attaches/isolates hub's 10 Mbps repeater bus from the stack's
data channel.
data channel.
100M Backplane
Attaches/isolates hub's 100 Mbps repeater bus from the
stack's data channel.
stack's data channel.
H/W Ver
Hardware version number of the repeater board.
# of Ports
Indicates whether this device has 12 or 24 repeater ports.
SNMP Agent
Baudrate
Rate at which data is sent between the Agent Module's serial
port and the connected device. Supported baud rates are 9600,
19200 and 38400 bps.
port and the connected device. Supported baud rates are 9600,
19200 and 38400 bps.
Bootup Option
Specifies whether or not IP functionality is enabled (via manual
configuration), set by Boot Protocol (BootP), or disabled.
Options include:
configuration), set by Boot Protocol (BootP), or disabled.
Options include:
IP Enabled - IP functionality is enabled based on the
default or configured settings. (The default is IP Enabled.)
default or configured settings. (The default is IP Enabled.)
BootP Get IP - IP is enabled but will not function until a
BootP reply has been received. BootP requests will be
periodically broadcast by the hub in an effort to learn its IP
address.
BootP reply has been received. BootP requests will be
periodically broadcast by the hub in an effort to learn its IP
address.
MAC Address
Physical address of the Agent Module.
H/W Version
Hardware version number of the Agent Module.
POST Ver
Version number of the Agent Module's Power-on Self-test.
System Ver
System firmware version.
Switch Module
Type
Indicates if an internal switch or media extension module is
installed.
installed.