Agilent Technologies E4445A User Manual
Chapter 5
443
One-Button Measurement Functions
Meas Setup (Multi-Carrier Power—MCP)
One-
But
ton
M
M
e
asur
e
m
e
nt
Funct
Funct
ions
Example:
MCP:CARR:AUTO 0
MCP:CARR:AUTO?
MCP:CARR -100
MCP:CARR?
5.19.9
Limit Test
Pressing
Limit Test
turns the testing of the limit line on or off. When
Limit Test
is set to
On
,
each offset is compared to its upper and lower offset limit. In those cases where the power
exceeds the limit, a red “F” is placed next to the dBc result to indicate a failure. If there are
any failures, the pass/fail indicator area show “FAIL” in red; if there are none, it shows
“PASS” in green. Any offsets that are in the off state (see
exceeds the limit, a red “F” is placed next to the dBc result to indicate a failure. If there are
any failures, the pass/fail indicator area show “FAIL” in red; if there are none, it shows
“PASS” in green. Any offsets that are in the off state (see
) are not
measured and their results will not be displayed on screen.
Key Path:
Meas Setup
,
More
State Saved:
Saved in instrument state.
Factory Preset: Off
History:
Added with firmware revision A.02.00