Yamaha RX-Z11 User Manual

Press and hold the button you want to program on 
the other remote control until “OK” appears in the 
display window (4).
“NG” appears in the display window (4) if learning was 
unsuccessful. In this case, start over from step 4.

y
• When you want to program another function, repeat steps 4 and 6.
• When you continuously want to program another function for 

another control area, set the operation mode selector to FSOURCE 
and then press 5SELECT l / h repeatedly and then repeat steps 4 
through 6. If you want to select “TV” as the control area, set the 
operation mode selector to FTV and then repeat steps 4 through 6.

Press G

SETUP again to exit the setup menu.

• “ERROR” appears in the display window (4) on the remote control if you 

press a button not indicated in the respective step, or when you press more 
than one button simultaneously.

• This remote control can learn approximately 200 functions. However, 

depending on the signals learned, “FULL” may appear in the display 
before you program 200 functions. In this case, clear unnecessary 
programmed functions to make room for further learning.

• Learning may not be possible in the following cases:

– when the batteries in the remote control for this unit or other components 

are weak.

– when the distance between the two remote controls is too great or too 

small.

– when the remote control infrared windows are not facing each other at 

the appropriate angle.

– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or uncommon.

You can change the name of the control area (input source) that 
appears in the display window (4) on the remote control if you 
want to use a different name than the factory preset. This feature is 
useful when you have set an control area to control a different 
component.

Set the operation mode selector to F

SOURCE and 

then press an input selector button (3) to select the 
desired control area.
The name of the control area you want to customize appears in 
the display window (4) on the remote control.

Press G

SETUP using a ballpoint pen or similar 

object.
“SETUP” appears in the display window.

Press 9k / n repeatedly to select “RNAME” and then 
press 9

ENTER.

The remote control enters the renaming mode. “RNAME” and 
the name of the selected control area appears in the display 
window alternately.

y
You can change the renamed control area by pressing an input selector 
button (3) or 5SELECT l / h repeatedly.

Press 9k / n repeatedly to select 3-letter name or 5-
letter name you want to edit.
Each control area has both 3-letter name and 5-letter name. 
You can rename the 3-letter name and 5-letter name 
independently.

Press 9

ENTER.

The edit screen of the name of the currently selected control 
area appears in the display window (4).

OK

BD/HD

SETUP

RNAME

BD/HD

BD

BD/HD

BD/HD