Yamaha RX-Z11 User Manual

You can program remote control codes from other remote controls. 
Use the learning feature if you want to program functions not 
included in the basic operations covered by the remote control 
codes, or an appropriate remote control code is not available. You 
can program the function of other remote control to the buttons in 
the highlighted areas in the following illustration. The buttons can 
be programmed independently for each control area.

• The remote control transmits infrared rays. If the other remote control also 

uses infrared rays, this remote control can learn most of its functions. 
However, you may not be able to program some special signals or 
extremely long transmissions. Refer to the operating instructions for the 
other remote control.

• You cannot program the desired remote control code even if you select the 

buttons in the highlighted area in the above illustration depending on the 
selected control area and the assigned library.

Set the operation mode selector to F

SOURCE and 

then press an input selector button (3) to select the 
desired control area.
The name of the control area you want to customize appears in 
the display window (4) on the remote control.

y
• You can also select the desired control area by pressing 5SELECT 

l / h repeatedly.

• If you want to select “TV”, set the operation mode selector to FTV.

Make sure that the operation mode selector is set to FSOURCE or 
FTV. When you set the operation mode selector to FAMP and 
program a remote control codes from other remote controls, the 
programmed key cannot operate the amplifier function of this unit.

Press G

SETUP using a ballpoint pen or similar 

object.
“SETUP” appears in the display window (4).

Press 9k / n repeatedly to select “LEARN” and then 
press 9

ENTER.

The remote control enters the learning mode. “LEARN” and 
the name of the selected control area appears in the display 
window (4) alternately.

Place this remote control about 5 to 10 cm (2 to 4 in) 
apart from the other remote control on a flat surface 
so that their infrared transmitters are aimed at each 
other and then press 9

ENTER.

“L–KEY” appears in the display window (4).

Press the button for which you want to program the 
new function.
“START” appears in the display window (4).

DVD

SETUP

START

DVD

L-KEY

START