Yamaha RX-Z11 User Manual

Press 9l / h repeatedly to move the cursor (_) to 
the position you want to edit.

Press 9k / n repeatedly to select and enter the 
desired character.
Pressing 9k changes the character as follows:
A to Z, a to z, 0, 1 to 9, space, - (minus), + (plus), / (slash) and 
: (colon).

y
Pressing 9n changes the characters in reverse order.

Press 9

ENTER to set the new name.

“OK” appears in the display window (4) on the remote 
control if renaming was successful.

y
When you want to rename the another name of the selected control 
area, press the input selector button (3) or 5SELECT l / h 
repeatedly to select the desired control area and then press 9ENTER 
and then carry out the operations of steps 4 through 9.

Press G

SETUP again to exit the setup menu.

The new name of the control area appears in the display 
window (4).

“ERROR” appears in the display window (4) on the remote control if you 
press a button not indicated in the respective step, or when you press more 
than one button simultaneously.

The macro programming feature makes it possible to perform a 
series of operations with the press of a single button. For example, 
when you want to play a CD, normally you would turn on the 
components, select the CD input, and press the play button to start 
playback. The macro programming feature lets you perform all of 
these operations simply by pressing the CD macro button. The 
buttons listed as macro buttons below are factory set with macro 
programs. You can also program your own macros (see page 129).

■ Recalling programmed macro-operations

Press H

MACRO on the remote control.

Press the desired macro button.
“M:the 3-letter name of the selected control area” (for 
example, “M:DVD”) appears in the display window (4), and 
this unit transmits the programmed functions. When you press 
DSTANDBY or EPOWER, “M:STB” or “M:PWR” appears 
in the display window (4), and this unit transmits the 
programmed functions.

Press H

MACRO again to exit from the macro-

• While the remote control is running a macro program, it does not accept 

any other operation until it has completed running the program (the 
transmission indicator in the display stops flashing).

• Continue to aim the remote control at the component the macro is 

operating until the macro operation is complete.

• If you do not complete each of the operations within 30 seconds, this unit 

automatically exits from the macro-operation mode.

HDDVD

MACRO