3M 11000 User Manual

18 

 (continued)

2011 June

a80f-if-NA

Before connecting the machine to the mains please 

carry out the following operations:

 Make sure that the socket is provided with  

 

  an earth protection circuit and that both the  

 

  mains voltage and the frequency match 

  

the 

specifi cations on the name plate. 

  Check that the connection of the machine 

 

  to the mains meets the safety regulations in 

  

your 

country. 

For technical specifi cations:  
See Section 4 - Specifi cations

-   Push the 

  LATCHING EMERGENCY STOP BUTTON.
-   The main switch is normally turned OFF.

Connect the power cord supplied with the machine 

to a wall socket using a plug which complies with the 

safety regulations of your country.

  The machine is fi tted with a main switch. 

 

  The user will be responsible for testing the 

 

  short-circuit current in its facility and should 

 

  check that the short-circuit amperage setting 

 

  of the machine is compatible with all the 

 

  components of the mains system.

•

   To reduce the risk associated with 

− 

Read, understand, and follow all safety 

    and operating instructions before operating 

    or servicing the Infeed Conveyor/Case Sealer.

•  

− 

Position electrical cord away from foot 

    and vehicle traffi c.

Refer to Figure 7-4 for installation Setup. Infeed 
convey-or bed must be level and equal to case sealer 
bed height. Secure infeed conveyor mounting brack-
ets to infeed conveyor and case sealer as shown.

Plug the air line from the infeed conveyor into the 
designated port on the case sealer as shown 
(Figure 7-5).

The infeed conveyor requires a 5.2 bar gauge pres-
sure [75 PSIG], 28 litre/min @ 21°C, 1.01 bar 
[1.0 SCFM] compressed air supply.

Remove all packaging materials and tools from the 
conveyor before connecting the air line to energize 
the pneumatic components.

The electrical control box, shown in Figure 7-5, contains 
the "On/Off" switch with pre-set circuit breaker.

A power supply cord extends from the bottom of the 
electrical control box (switch). Plug this cord into the 
receptacle on the lower left side (infeed end) of the 
a80f-if

 case sealer frame as shown in Figure 2-4.

ELECTRIC

  Use care when working with 

 compressed 

air.