3M 11000 User Manual

19 

2011 June

a80f-if-NA

 (continued)

The air valve has provisions for lock out/

 

tag out according to plant regulations.

  Use care when working with 

 compressed 

air.

(continued)

5.  Ensure that infeed conveyor rollers are level with 

machine infeed rollers. Adjust position of

 

the bed height and infeed conveyor before 

 

tightening all screws. When adjusting Infeed Conveyor 

 

Legs, block up the machine frame to allow 

 

adequate leg adjustment  This will help to prevent 

 

damage to the boxes and ensure proper 

 performance.
6.  Remove the Plug and insert/connect the main 

 

air supply line to the "T" connector located at the 

 

midpoint/middle at end of machine (see Figure 7-5).

7.  Connect Electric Plug.

1.  Install Infeed Conveyor in production line.    

When installing the Infeed Conveyor, be sure to 
observe the following guidelines.

 

a.  Infeed Conveyor must be installed level – it is not 
designed to convey boxes uphill.

 

b.  Production Line must convey boxes to 
Infeed Conveyor at the target speed indicated in 
Specifi cations (Section 4) and can be set as shown 
in Figure 7-6.

 

c.  Precautions must be taken to prevent excessive 
box pressure against the Infeed Conveyor infeed gate.  
This will help to prevent damage to the boxes and 
ensure proper performance.

 

d.  Infeed and exit conveyors must provide straight 
entrance and exit of boxes to/from Infeed Conveyor 
and exit conveyor must positively convey boxes away 
from machine

1.  Remove the conveyor and the package of parts  

from the carton.

2.  Verify that the package contains two fl at plates, 

four (4) M8 x 20 hex socket head screws, and 
four (4) M8 fl at washers.

3.   To assemble the infeed conveyor, refer to 

 and locate the bolt holes on the infeed  

end of the Infeed Conveyor frame. 

4.  Insert a screw in each hole and attach conveyor to 

frame so that only a few threads take hold.  

   Be sure to line up and level the Machine and 

 

 

Infeed Conveyor Rollers. Adjustments can be 

 

made to the position of the infeed conveyor 

 

before tightening screws.

• 

− 

Use the appropriate rigging and material 

handling equipment when lifting or 

repositioning this equipment.

• 

− 

Always unplug electric and turn the valve "Off" 
when air supply line is being connected or 
disconnected.

• 

− 

Turn electrical and air supply off and 
disconnect before performing any 
adjustments, maintenance or servicing the 
machine.