Combi 8000 Series User Manual
LATCH System On This Car Seat:
The LATCH System on the Tyro
™
Car Seat consists of a lower anchor belt with lower anchor
connectors .
The lower anchor connectors on the car seat connect to the LATCH System in a vehicle.
LATCH System On Vehicles:
Child restraint anchorage system or the LATCH System in the vehicle consists of two lower
anchorages located at the vehicle seat bight and a top tether anchorage (fig. b). Refer
to vehicle owner’s manual for seating locations which have the LATCH System.
anchorages located at the vehicle seat bight and a top tether anchorage (fig. b). Refer
to vehicle owner’s manual for seating locations which have the LATCH System.
The Tyro
™
uses the lower anchor anchorages but does not use the top tether.
Lower anchorages are visible in some vehicles and others are not. Those that are not
visible are identified by a solid color round dot on the vehicle upholstery or a round dot with
a picture of a car seat in the center as shown in fig. c.
visible are identified by a solid color round dot on the vehicle upholstery or a round dot with
a picture of a car seat in the center as shown in fig. c.
The vehicle manufacturer may provide funnel guides to separate the
vehicle seat cushions providing easier access to the lower anchorage.
See vehicle owner’s manual.
vehicle seat cushions providing easier access to the lower anchorage.
See vehicle owner’s manual.
11
2
4
5
(fig. c)
(fig. b)
5
3
1
3
(fig. a)
2
2
1
4
Section 8 - LATCH System
12
A
ttachment Of Infant Car Seat To Base:
Section 9 - Installation of Infant Car Seat in Vehicle
WARNING
DEATH or SERIOUS INJURY can occur
• Use only in a rear-facing position when using this infant car seat in the vehicle.
• Secure this child restraint with LATCH System or a vehicle seat belt as shown in this manual.
• LATCH System or vehicle seat belt must stay tightly adjusted around car seat or base at all times. If
LATCH System or vehicle seat belt does not stay tight, read the vehicle owner’s manual and “Vehicle Seat
Belts” section in this manual.
Belts” section in this manual.
• Rear-facing car seat must be properly reclined:
- Too reclined can result in injury or ejection.
- Too upright can result in breathing difficulties.
• After installing infant car seat into base, lift carrier to be sure it is securely locked.
Removal Of Infant Car Seat From Base:
Push in handle buttons on each side of handle and rotate handle to upright carry position
(see “Carry Handle Operation” section).
(see “Carry Handle Operation” section).
Lift red release handle up , rotate infant car seat forward and lift car seat from
base (fig. a).
base (fig. a).
1
2
3
(fig. a)
1
2
3
1
2
Red Release
Handle